HDL-M/R8.16.1-CD

These switch actuators can be used to control the switch loads, such as:

• Lighting
• Heating control
• current detection

Product and function overview

The switch actuators are the modular installation devices, with 4, 8 and 12 outputs for selection, using EIB BUS connection terminals to connect to the system. The switch actuators are connected to the AC power supply directly instead of an extra voltage supply. It is able to use the Engineering Tool Software ETS with a knxprj file to allocate the physical address and set the parameters. It is able to switch from 4 to 12 independent electrical AC loads by the switch actuators with maximum output of 16A per output and manual switch, as well as visible switching status.

There are same following programming functions for each output:

• time function: on/off delay
• staircase function
• scene, preset control: 8bit/1bit
• logic operation: AND, OR, XOR
• status response
• forced operation and safe function
• threshold function setup
• pwm control
• selection of preferred status after bus voltage failure and recovery
• current detecting